This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

[OLD] LogicMachine firmware 2020.07
#48
(25.09.2020, 12:19)admin Wrote: You should use KNX project import instead of ESF file
Thank you admin for the quick reply.

Since its a new function I haven't used it yet but will give it a try on my next project. Nice to know!


Messages In This Thread
RE: [PRE-RELEASE 3] LogicMachine firmware 2020.07 - by manos@dynamitec - 25.09.2020, 12:24

Forum Jump: