Logic Machine Forum
LM 4 Lite does not respond to requests - Printable Version

+- Logic Machine Forum (https://forum.logicmachine.net)
+-- Forum: LogicMachine eco-system (https://forum.logicmachine.net/forumdisplay.php?fid=1)
+--- Forum: Gateway (https://forum.logicmachine.net/forumdisplay.php?fid=10)
+--- Thread: LM 4 Lite does not respond to requests (/showthread.php?tid=2114)



LM 4 Lite does not respond to requests - Igor68 - 09.06.2019

hello, help me solve this problem.

My logic machine 4 after 5-6 days stops responding to all requests. Ping is not determined, although special programs see un IP address and MAC address. It helps only soft hardware reset. Then again, 5-6 days everything works without problems What could it be?


RE: LM 4 Lite does not respond to requests - Daniel - 10.06.2019

most likely card is in read only mode.


RE: LM 4 Lite does not respond to requests - Igor68 - 10.06.2019

but I don't have a card ...


RE: LM 4 Lite does not respond to requests - Daniel - 10.06.2019

Every LM has a card just first check if it is in read only mode. Change some settings in LM, sync project and reboot. If after reboot your changes are lost then it is.


RE: LM 4 Lite does not respond to requests - Igor68 - 10.06.2019

Thanks for the quick response! How can I put the card in recording mode?


RE: LM 4 Lite does not respond to requests - Daniel - 10.06.2019

You cant, it has to be replaced and re flashed.
See here http://openrb.com/reflash-logicmachine3-and-streaming-player-software/


RE: LM 4 Lite does not respond to requests - Igor68 - 10.06.2019

Thanks for the help! I will try


RE: LM 4 Lite does not respond to requests - Igor68 - 15.06.2019

Daniel, hello.
After the project changes and restarts, the changes remain in effect. So the problem is not in the memory card. Any more ideas to solve this problem?)


RE: LM 4 Lite does not respond to requests - Daniel - 17.06.2019

(15.06.2019, 12:20)Igor68 Wrote: Daniel, hello.
After the project changes and restarts, the changes remain in effect. So the problem is not in the memory card. Any more ideas to solve this problem?)

Hm, then probably some memory issue.  How much memory do you use? Do you have lot of trends?