Import empty group addressess from ETS - Printable Version +- Logic Machine Forum (https://forum.logicmachine.net) +-- Forum: LogicMachine eco-system (https://forum.logicmachine.net/forumdisplay.php?fid=1) +--- Forum: Gateway (https://forum.logicmachine.net/forumdisplay.php?fid=10) +--- Thread: Import empty group addressess from ETS (/showthread.php?tid=3027) |
Import empty group addressess from ETS - Tokatubs - 26.11.2020 Have a project that will be imported into the Lm5. The file has been created in ETS5 with group addresses. But lot of them are still empty because products have not been added yet. But i want to import them into LM and when the programmer links the products i the telegrams start. Reason is that i am doing an integration to bacnet. And therefor i want to start on this work, and the work with the BMS system on the other side. RE: Import empty group addressess from ETS - Daniel - 26.11.2020 Import KNXproj file. RE: Import empty group addressess from ETS - Tokatubs - 26.11.2020 Yes, i know. But it doesnt import the empty groups. RE: Import empty group addressess from ETS - Daniel - 26.11.2020 Did you select the option to import groups without dpts? RE: Import empty group addressess from ETS - Tokatubs - 26.11.2020 (26.11.2020, 12:01)Daniel. Wrote: Did you select the option to import groups without dpts?Yes, will try it again. RE: Import empty group addressess from ETS - Mirco - 26.11.2020 It is a problem of ETS, it exports only goup addresses that are used (linked) into a device. If you would solve it, add into the ETS project a Dummy and link all group addresses |