+- Logic Machine Forum (https://forum.logicmachine.net)
+-- Forum: LogicMachine eco-system (https://forum.logicmachine.net/forumdisplay.php?fid=1)
+--- Forum: Hardware (https://forum.logicmachine.net/forumdisplay.php?fid=12)
+--- Thread: LM access but not giving Commands to KNX (/showthread.php?tid=3286)
LM access but not giving Commands to KNX - vmic - 06.04.2021
Hi I have instellad an LM5p2-DR in a new project for the first time and I can access the device with IP I can ping it but when I am pressing for turning ON a light then it doesn't workÂ
Why? I have connected the KNX (which I mesaured correct ) but I can't access the KNX somehow.
Is it possible to help me please?
RE: LM access but not giving Commands to KNX - Daniel - 06.04.2021
Did you select correct KNX Mode? System-Network-KNX connection. It should be TP-uart.
RE: LM access but not giving Commands to KNX - vmic - 06.04.2021
(06.04.2021, 08:19)Daniel. Wrote: Did you select correct KNX Mode? System-Network-KNX connection. It should be TP-uart.
Oh yes I had it as IP Tunneling! Thank you very much!