+- Logic Machine Forum (https://forum.logicmachine.net)
+-- Forum: LogicMachine eco-system (https://forum.logicmachine.net/forumdisplay.php?fid=1)
+--- Forum: Gateway (https://forum.logicmachine.net/forumdisplay.php?fid=10)
+--- Thread: Zwave - Fibaro Motion Sensor (/showthread.php?tid=4)
RE: Zwave - Fibaro Motion Sensor - Igori - 28.01.2020
Good time!
I'm testing z-wave.me stick to control wireless devices. And I have a few questions.
1. How to get feedback into a KNX network from a z-wave device? I guess I have to "write to bus", isn't it?
2. What does the "pool interval" (z-wave network settings) parameter mean, and why I can't change it?
3. Why do I need "pooling" checkbox, and why I can't set it too?
Thanks
RE: Zwave - Fibaro Motion Sensor - Daniel - 28.01.2020
1. Yes
2. How often stick check if device is Alive, Dead, or in Sleep
3. If you have sensor and you want to pool value from it.
RE: Zwave - Fibaro Motion Sensor - Igori - 28.01.2020
(28.01.2020, 13:51)Daniel. Wrote: 1. Yes
2. How often stick check if device is Alive, Dead, or in Sleep
3. If you have sensor and you want to pool value from it.
Many thanks, Daniel!
1. Can I get feedback to another KNX address?
2. Why does not change the value? (pool interval and pooling checkbox)
RE: Zwave - Fibaro Motion Sensor - Daniel - 28.01.2020
1. What do you mean?
2. Don't know but it is not so important.
RE: Zwave - Fibaro Motion Sensor - Igori - 29.01.2020
(28.01.2020, 15:13)Daniel. Wrote: 1. What do you mean?
2. Don't know but it is not so important.
Hi!
1. The visualization control has the command send address and the feedback address.
2. In my case, no updates happen at all. For example, if a z-wave device is turned off, its status will change to "dead" only after rebooting LM.
Thanks