+- Logic Machine Forum (https://forum.logicmachine.net)
+-- Forum: LogicMachine eco-system (https://forum.logicmachine.net/forumdisplay.php?fid=1)
+--- Forum: Gateway (https://forum.logicmachine.net/forumdisplay.php?fid=10)
+--- Thread: LM data loss (/showthread.php?tid=4813)
LM data loss - rw_echo - 07.06.2023
I have an LM (DR), and every time I make changes to the program, I click on the "snyc project data" button. However, after the LM is powered on again, the program inside is lost. I don't know what happened. Can anyone help me? Thank you in advance.
RE: LM data loss - Bitver - 07.06.2023
I can't vouch to say for sure, but it seems that this rarely happened to me too
RE: LM data loss - stonecroft - 07.06.2023
Hi.
Sounds that your SD-card is in read only mode.
Make a backup of your project and replace the card using this guide.
https://openrb.com/reflash-logicmachine3-and-streaming-player-software/
RE: LM data loss - admin - 07.06.2023
System config > System > Shutdown is the correct procedure before powering the device down. It also does full project synchronization. Once LEDs stop blinking you can safely remove the power.