+- Logic Machine Forum (https://forum.logicmachine.net)
+-- Forum: LogicMachine eco-system (https://forum.logicmachine.net/forumdisplay.php?fid=1)
+--- Forum: General (https://forum.logicmachine.net/forumdisplay.php?fid=2)
+--- Thread: Wiser For KNX v2.8.0 and HTTPS (/showthread.php?tid=5302)
Wiser For KNX v2.8.0 and HTTPS - SigmaTec - 14.03.2024
Hi all,
I installed the v2.8.0 Schneider Electric firmware on a Wiser For KNX 2.
At startup I accepted to be in HTTPS, but since then it has been impossible to access remotely via @IP:port -> browser message "Https not secure" .
Can I switch back to http (via a system setting)?
Can I reinstall v2.8.0 on itself to switch back to http?
Thank you in advance for your assistance.
Have good evening.
RE: Wiser For KNX v2.8.0 and HTTPS - Daniel - 14.03.2024
No need to install old firmware, you can change it in System-Services-HTTP Server
RE: Wiser For KNX v2.8.0 and HTTPS - SigmaTec - 14.03.2024
(14.03.2024, 17:05)Daniel Wrote: No need to install old firmware, you can change it in System-Services-HTTP Server
Hi Daniel,
nothing changes with this parameter :
Services > Serveur HTTP > Mode HTTPS > HTTP et HTTPS activés
Am I wrong ?
RE: Wiser For KNX v2.8.0 and HTTPS - Daniel - 14.03.2024
Change language to EN and post again.
RE: Wiser For KNX v2.8.0 and HTTPS - SigmaTec - 14.03.2024
excuse me...
System > Services > HTTP server > HTTPS Mode > HTTP and HTTPS enabled
RE: Wiser For KNX v2.8.0 and HTTPS - Daniel - 14.03.2024
Yes this is corect.
RE: Wiser For KNX v2.8.0 and HTTPS - SigmaTec - 14.03.2024
...correct but no result after rebooting the product !
RE: Wiser For KNX v2.8.0 and HTTPS - Daniel - 14.03.2024
Clear browser cache or try different.
RE: Wiser For KNX v2.8.0 and HTTPS - SigmaTec - 14.03.2024
I try this yet, but message is always "connexion refused"
RE: Wiser For KNX v2.8.0 and HTTPS - Daniel - 14.03.2024
I'm working on 3.0.0 and it works there. BTW 2.8.0 has serious bug 2.8.3 fallowed short after.
RE: Wiser For KNX v2.8.0 and HTTPS - SigmaTec - 14.03.2024
So, in "private navigation" it works fine. You'are write, it's a problem of browser cache.
Many thank's Daniel.
Still effective as usual !