+- Logic Machine Forum (https://forum.logicmachine.net)
+-- Forum: LogicMachine eco-system (https://forum.logicmachine.net/forumdisplay.php?fid=1)
+--- Forum: Hardware (https://forum.logicmachine.net/forumdisplay.php?fid=12)
+--- Thread: Device LED blinking meaning (/showthread.php?tid=692)
Device LED blinking meaning - leondias - 22.03.2017
Is there any info about devices Activity LED blinking?
On our device it's blinking green/red
RE: Device LED blinking meaning - edgars - 22.03.2017
Please see LED meaning attached.
RE: Device LED blinking meaning - admin - 22.03.2017
"Heartbeat" flash frequency is a hyperbolic function of the 5-minute load average. The higher the system load, the faster it will blink.
RE: Device LED blinking meaning - admin - 22.03.2017
LED1 shows current system load, LED2 turns green when system is fully loaded.
RE: Device LED blinking meaning - Thomas - 23.03.2017
(22.03.2017, 13:26)admin Wrote: LED1 shows current system load, LED2 turns green when system is fully loaded.
Hi
Is this information valid for LM5 too?
Thank you
RE: Device LED blinking meaning - admin - 23.03.2017
All devices behave the same.
RE: Device LED blinking meaning - Erwin van der Zwart - 23.03.2017
(22.03.2017, 12:46)leondias Wrote: Are you talking about LED1 or LED2?
As I mentioned, LED2 is now blinking red-green. Yesterday it was only green
Hi,
You probably have enabled the device identification, this works like blinking LED on KNX device to determine what device you have, this is usefull when having multiple controllers.
Try: Utilities -> Click on the black arrow inside the System button -> Toggle device identification
BR,
Erwin
RE: Device LED blinking meaning - leondias - 23.03.2017
(23.03.2017, 12:29)Erwin van der Zwart Wrote:(22.03.2017, 12:46)leondias Wrote: Are you talking about LED1 or LED2?
As I mentioned, LED2 is now blinking red-green. Yesterday it was only green
Hi,
You probably have enabled the device identification, this works like blinking LED on KNX device to determine what device you have, this is usefull when having multiple controllers.
Try: Utilities -> Click on the black arrow inside the System button -> Toggle device identification
BR,
Erwin
Thanks, you are right
