+- Logic Machine Forum (https://forum.logicmachine.net)
+-- Forum: LogicMachine eco-system (https://forum.logicmachine.net/forumdisplay.php?fid=1)
+--- Forum: General (https://forum.logicmachine.net/forumdisplay.php?fid=2)
+--- Thread: Hotspare LM (/showthread.php?tid=717)
Hotspare LM - Thomas - 04.04.2017
But Hi
Is there a way how to use a secondary LM on the same bus as a hot spare device in case of the primary LM fails?
Or what is the best practice?
I've seen a simple example where scripts were disabled on the spare LM when the primary LM was available on the KNX bus. But it didn't disable schedulers etc.
RE: Hotspare LM - Thomas - 07.04.2017
I'm trying to set up the spare LM5. But everytime I try "Import Neighbor" I'm getting
Error: 500
message.
Do you have any idea what's going on?
RE: Hotspare LM - Erwin van der Zwart - 07.04.2017
Hi,
Did you enable remote services on the controller you want to import objects from?
BR,
Erwin
RE: Hotspare LM - Thomas - 08.04.2017
Hi,
yes I checked it twice. There has been remote services enable at both devices.
In "KNX connection" there has been set:
Enable only secure connection checked
Both Encryption keys have been identical
RE: Hotspare LM - Erwin van der Zwart - 08.04.2017
Hi,
Encryption uses also timestamps into the data to avoid recording and replication.
Are the timezones and date/time equal on both controllers?
BR,
Erwin
RE: Hotspare LM - admin - 10.04.2017
Remote services are not connected with KNX security settings in any way. Have you tried it with the beta FW that I've sent to you?
RE: Hotspare LM - Thomas - 10.04.2017
(10.04.2017, 07:19)admin Wrote: Remote services are not connected with KNX security settings in any way. Have you tried it with the beta FW that I've sent to you?
Hi
I tried with both. Source was always the actual stable firmware (and I can't change it because it's a 'production' device). Target was first the original firmware I bought (from december). Then I replaced the firmware by the testing version you send me and tried again. With the same result.
But now when I'm thinking about it I'm not 100% sure it was error 500 in my first attempt with old firmware. I will test it again.