Modbus: write to bus enable

[Domoticatorino]

Hi,
in order to reduce KNX traffic bus I have disable the flag "write to bus" in modbus oject map.

Unfortunately LM is going on to write on bus. What do you suggest?

Thanks.

[Daniel]

You can use Virtual objects but are you sure it is writing? Which fw do you use?
You can also add Value send delta: to limit traffic.

[Domoticatorino]

You can use Virtual objects but are you sure it is writing? Which fw do you use?
You can also add Value send delta: to limit traffic.

Hi Daniel,

unfortunately they are not virtual object. But I expect that with that flag trafficis reduced. I would like to avoid to rebuild objects.

Firmware is the last one.

In the meanwhile I change the value send.

[Daniel]

What is latest one? My latest is definitely not the same what yours
RC1?

[Domoticatorino]

You're right.

What I have downloaded from your post dated october 2019 for LM5 lite.

It is called lm5m3-20191015

Thanks.