Posts: 1820
Threads: 8
Joined: Jul 2015
Reputation:
121
Hi,
In the past it was possible to embed a visu page from other controllers by iframe into a ''master' controller.
Due to tightened policies in modern browsers this results in error due to same source policy headers.
Is there a way to solve this?
Posts: 8911
Threads: 48
Joined: Jun 2015
Reputation:
508
Enable "Allow external access via iframe" in Vis. configuration.
Posts: 1820
Threads: 8
Joined: Jul 2015
Reputation:
121
Thanks! Missed that one (:
Posts: 363
Threads: 83
Joined: Jan 2021
Reputation:
0
Hello
How to insert vis. from another SL?
I enabled "Allow external access via i frame "
in visualization I added Frame and insert the URL eg: "http://*.*.*.*/scada-vis"
but it didnt work
Best Regards,
Posts: 8911
Threads: 48
Joined: Jun 2015
Reputation:
508
You need to disable password access to the visualization in User access settings on the device that your embedding via iframe.
Posts: 276
Threads: 39
Joined: Feb 2016
Reputation:
1
(30.05.2022, 06:33)admin Wrote: You need to disable password access to the visualization in User access settings on the device that your embedding via iframe.
there is security issue if you disable it...
-----------
FRANCE SMARTHOME & SMARTBUILDING INTEGRATION
SE ECO EXPERT
Posts: 8911
Threads: 48
Joined: Jun 2015
Reputation:
508
Of course but there's no other way to use it in an iframe. Alternative solution is to create the whole visualization in a single device and exchange values via KNX/IP. But this in only for the visualization, not schedulers or trends.
Posts: 363
Threads: 83
Joined: Jan 2021
Reputation:
0
hello
is there a solution fore remote access.
this solution work when access from local network or VPN. but how to solve access via remote IP
like change the iFrame ip depend on the ip used (local or remote)
Best Regards,
Posts: 25
Threads: 1
Joined: Apr 2020
Reputation:
2
So I have 15 LMs in the same network. They have around 4000 group addresses that are needed for the (new)Visu, So if I add master LM for new(Visu), what would be the best way to do this? It would be easiest for me if I could do the room visu's in existing LMs (that would be around 10-15 rooms in each) and link them to the master LM. This is Hotel and the rooms behind the LM's arent very logical due to it beeing repurposed building Like in LM1 there might be room 3 10 15 from 1st floor, 2nd floor 12 13 40 etc. Thx in advance.
Posts: 5812
Threads: 31
Joined: Aug 2017
Reputation:
266
If the total group addresses is 4k then I would add another LM and let it collect all data from other LMs and make one visu project on it for all.
------------------------------
Ctrl+F5
