1-Wire Beginner

[blackheath]

Can someone help me to set up 1-Wire sensors? I'm not very familiar with the LM yet. Thanks

[admin]

Sensors are discovered automatically once connected to 1-Wire bus. After that you can map sensor values to LM objects.

[blackheath]

OK. will be found automatically. but where can I find the LM objects? would like to bring this into the KNX.

---

can i find instructions or screenshots somewhere?

[admin]

Page 17:
https://openrb.com/wp-content/uploads/20...3.2022.pdf

[blackheath]

thank, knx is for me ok, but where can I find the 1-Wire sensors and how do I link them to KNX?
sorry, but beginner ;-)

[Daniel]

Do you have LM with 1-wire interface on it?

[blackheath]

no, 1-Wire Scheider Electric Wiser for KNX 1. Generation

[Daniel]

Wiser for KNX does not have this functionality, you must buy LM with 1-wire support and then all will be very clear.

[blackheath]

only usb interface

[Daniel]

Only LM support 1-wire

[blackheath]

shame, had understood that should go with a script

---

thanks

[Erwin van der Zwart]

There is no 1-wire interface (the physical connection of the wire) available on the Wiser for KNX so a 1-wire device cannot be connected to a Wiser for KNX controller, therefore you need a certain LM model with the physical interface.