can not connect after upgrade

[stevesu]

hi, i just installed a upgrade and now i'm unnable to connect to the webpage of my schneider wiser for knx,
i get the message "ERR_SSL_SERVER_CERT_BAD_FORMAT"

after installing there was a message about using https .

if someone could give a solution.

thanks

[Daniel]

SE FW is forcing you now to use HTTPS and browser will complain about not valid certificate. Depend of the browser you use it will look different but you must press 'advaned' and then proceed anyway.

[stevesu]

SE FW is forcing you now to use HTTPS and browser will complain about not valid certificate. Depend of the browser you use it will look different but you must press 'advaned' and then proceed anyway.

hi , normally i'm familiar with the advanced button, but it isn't there, using chrome.

[Daniel]

Try different browser, can you ping it?

[stevesu]

ping yes,
edge = no
firefox = yes

can i restore when i connect true firefox so i can use chrome again ?

[Daniel]

Clear the browser cache in Chrome and see again. For me Chrome works fine.

[stevesu]

Clear the browser cache in Chrome and see again. For me Chrome works fine.

solved it by in system > changing http modus to "http and https"
in browser adding the additional port number 

thanks