ZigBee Device won't Update BUS

[emme]

Hallo,

I have a tradfri 30W dimmer correctly paired with my LM5 Lite (i.mx6)

Device works perfectly but It looks not to update correctly the bus:

I have a dimmer button configured and I am ussumed to get the state change on the bus, but this does not hammpend.

Groups are connected correctly, ETS setup if fine, but I do not get events on bus.

No current dim % (1Byte)
No state feedback (1 bit)

this is the current config

Code:

Manufacturer: IKEA of Sweden
Model: TRADFRI Driver 30W

Device type: Router
Power source: Mains
Receive when idle: Yes

Endpoint 1
Profile: 260
Input clusters
- Basic (0)
- Identify (3)
- Groups (4)
- Scenes (5)
- OnOff (6)
- LevelCtrl (8)
- LightLink (4096)
- 64636
Output clusters
- Scenes (5)
- Ota (25)
- PollCtrl (32)
- LightLink (4096)

Endpoint 242
Profile: 41440
Input clusters
- GreenPwr (33)
Output clusters
- GreenPwr (33)

commands are received and executed correctly, but no fedback at all
thanks
marco

[admin]

Which App version are you using? Support for TRADFRI Driver 30W has been added recently. You might need to reset the device and pair it again for status feedback to work. In some case ZigBee device firmware upgrade is needed. Unfortunately at this moment LM does not support firmware upgrades for Ikea devices, you need Ikea gateway for this.