1-wire sensor management

[raunz]

Hi,

I'm a bit stuck, while trying to get 1-wire sensors working.
I have connected the sensors to the LM4 and the sensors appear in the listing on "1-wire" tab. Sensors are MAXIM DS18S20+

Thing that puzzles me, is that I can't access the "sensor settings" popup in UI. I can see in LM4 manual on page 135, that such popup exists, but how I can access it?
In the listing I have sensor ID, "poll interval": disabled and timestamp in "value received at". The printscreen is also attached.

If I delete the sensor with red "X", the row is deleted and it reappears again.

Please advise.

kind regards
--
rauno

[admin]

The version that you are using only supports DS18B20 sensors, but not DS18S20 sensors. Support will be added in the next release, in the meantime we can manually install a patch on your LM if you can provide remote access, please contact us by e-mail for that.

[Jørn]

The version that you are using only supports DS18B20 sensors, but not DS18S20 sensors. Support will be added in the next release, in the meantime we can manually install a patch on your LM if you can provide remote access, please contact us by e-mail for that.

Do you have an updated list of 1-wire sensors that are supported`? In my case for the LM5.

[admin]

Nearly all 1-wire devices are supported through scripting.
For now UI supports these devices, but new profiles can be added by request.

DS18S20, high precision digital thermometer (family 10)
DS2408, 8-channel addressable switch (family 29)
DS2413, dual channel addressable switch (family 3A)
DS18B20, programmable resolution digital thermometer (family 28)

[andeug]

The sensor will be shown into 1-wire menu immediately after connecting it to the LM4 1-wire interface? Or do I need to add a specific sensor profile?
I would like to test one temperature sensor which is making me troubles (I've wrote about in this topic).

[admin]

It will be discovered automatically, you don't need to assign any profile, just map required objects.