Hi,
I am trying to use 9 HDL Zigbee Valves but I am having problems using 5 of them. They seem to have different firmware from the others and I will probably need another JSON profile for them. I will attach the logs and series of photos to better explain the problem.
We will add MIGT05.19 to the same profile as Rti-Tek Thermostat. Consider adding a ZigBee router/repeater to your installation as your signal levels are really low and the communication might be unstable. Any permanently powered ZigBee device will do (smart plug, etc).
(06.10.2023, 09:57)admin Wrote: We will add MIGT05.19 to the same profile as Rti-Tek Thermostat. Consider adding a ZigBee router/repeater to your installation as your signal levels are really low and the communication might be unstable. Any permanently powered ZigBee device will do (smart plug, etc).
Great! Thank you for the short time answer. How long will it take though? Will I need to install another ipk? and finally will I need to re-do the initial configuration?
Recently, I went back to work with these smart valves, but I noticed that the "Heating control" address sets the valves either off or automatic, which is bad because they do not seem to work in automatic. I also noticed that if I were to set the Heating from the Zigbee control webpage, then it works flawlessly. Is there a way I can change the "Heating control" address to "OFF" and "HEATING" instead of "AUTOMATIC"?
hdl zigbee valve.zip (Size: 358.77 KB / Downloads: 7)
