[Profile] Modbus Read Multiple Coils

[iJAF]

Hi  !

I have to read aprox. 80 coil registers from each of several equips but I want to read the registers with just 1 request like I do with INT values.

I have tried with the following example (test with 4 variables) but it doesn't work !
(For reading holding registers this way works fine)

Any ideas?

Code:

{"name":"Test1","bus_datatype":"1","type":"coil","datatype":"bool","address":0,"writable":0,"read_count":4,"read_offset":0,"read_swap":"n" },
{"name":"Test2","bus_datatype":"1","type":"coil","datatype":"bool","address":0,"writable":0,"read_count":4,"read_offset":1,"read_swap":"n" },
{"name":"Test3","bus_datatype":"1","type":"coil","datatype":"bool","address":0,"writable":0,"read_count":4,"read_offset":2,"read_swap":"n" },
{"name":"Test4","bus_datatype":"1","type":"coil","datatype":"bool","address":0,"writable":0,"read_count":4,"read_offset":3,"read_swap":"n" }

(...)

[buuuudzik]

Please change address and try again. And what is the current result? What you have in Logs, Errors, Alerts?

And here you have some post about limits:
https://forum.logicmachine.net/showthread.php?tid=1278

[admin]

Multiple read for coils is not supported yet, we'll look into adding it to next firmware.

[iJAF]

Please change address and try again. And what is the current result? What you have in Logs, Errors, Alerts?

And here you have some post about limits:
https://forum.logicmachine.net/showthread.php?tid=1278

Which address ?

What happens with the 4 variables I have posted is that they have the same value (from the modbus address 0).

---

Multiple read for coils is not supported yet, we'll look into adding it to next firmware.

Okay, thank you.

It will be a very very important feature to have.

[iJAF]

Multiple read for coils is not supported yet, we'll look into adding it to next firmware.

Hi,

Is there any news about this feature ?

I'm testing a SL with FW 2.4.0 and is still not supported :\

Thank you

[Erwin van der Zwart]

There is already much newer FW for SL, try using 2.5.1

[Daniel]

This was never implemented, we are doing it right now.