This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

Using LM/Wiser "offline" (without KNX)
#1
I am programmering ETS remotely at the office (i.e. not at site).
At the office, I do not have KNX setup.
I would like to setup the LM/Wiser also at the office prior to going out to the site.
In particular:
1) Importing objects (that's easy) and
2) Configuring the visualization (mostly "Touch Configurator").

I do have the physical device at the office.

Therefore: Can I "program" the LM/Wiser via IP only or must it be connected to a KNX line?

Thanks
Reply
#2
You don't need KNX to configure LM.
Reply


Forum Jump: