modbus energy meter

[mariosp]

Hello guys! 
Its my first that i integrate with modbus. 

Im using an energy meter from legrand ( EMDX3) and i dont receive measurments and when i check the error logs i get this 
read failed :Illegal function. 
Does ever this happend to anyone else ? 
Here is my profile for the device that i builded 

[Daniel]

You are missing datatype - this will be defined in device manuals. Before making profile use Read test to find correct configuration.

[mariosp]

You are missing datatype - this will be defined in device manuals.  Before making profile use Read test to find correct configuration.

When i try to do it i get Illegal fuction and illegal data value

[Daniel]

Do you have manuals with registry definition?

[mariosp]

Do you have manuals with registry definition?

yes , here it is

[Daniel]

You have registers, not inputregisters. Try also subtracting register address by 1

[mariosp]

You have registers, not inputregisters. Try also subtracting register address by 1

 I tried Both but unfortunately doesnt work

[admin]

Try running Read test with the following parameters and post the results.

- Function: Input register (#4)
- Address: 4096
- Data type: uint32
- Read swap: Word (CDAB)

Also try Function = Holding register (#3)

[mariosp]

Try running Read test with the following parameters and post the results.

- Function: Input register (#4)
- Address: 4096
- Data type: uint32
- Read swap: Word (CDAB)

Also try Function = Holding register (#3)

With holding register i get the volts.. but i dont get the value in the group address.

[Daniel]

Try this

Code:

"address": 4096,
"name": "Voltage L1",
"bus_datatype": "float32",
"type": "register",
"units": "V",
"description": "Voltage of phase L1",
"datatype": "uint32",
"value_multiplier": 0.001

[mariosp]

Try this

Code:

"address": 4096,
"name": "Voltage L1",
"bus_datatype": "float32",
"type": "register",
"units": "V",
"description": "Voltage of phase L1",
"datatype": "uint32",
"value_multiplier": 0.001

it worked, i will do it for all and i will update you

---

Try this

Code:

"address": 4096,
"name": "Voltage L1",
"bus_datatype": "float32",
"type": "register",
"units": "V",
"description": "Voltage of phase L1",
"datatype": "uint32",
"value_multiplier": 0.001

it worked, i will do it for all and i will update you

[mariosp]

It works perfecty!!! 
Thank you gus i will add the profile so if anynone need it to be ready!!