This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

KNX Device Watchdog
#1
Hello,

Is there a way to use a resident or a scheduled script to check if a device in the knx is alive by checking if the phys. address is present in the bus?

Thank you in advance
Reply
#2
(30.01.2019, 08:31)manos@dynamitec Wrote: Hello,

Is there a way to use a resident or a scheduled script to check if a device in the knx is alive by checking if the phys. address is present in the bus?

Thank you in advance

Please check this post:
https://forum.logicmachine.net/showthrea...nxlib.ping
Done is better than perfect
Reply
#3
(30.01.2019, 08:37)buuuudzik Wrote:
(30.01.2019, 08:31)manos@dynamitec Wrote: Hello,

Is there a way to use a resident or a scheduled script to check if a device in the knx is alive by checking if the phys. address is present in the bus?

Thank you in advance

Please check this post:
https://forum.logicmachine.net/showthrea...nxlib.ping

Hello buuuudzik,

Thank you for the reply. It worked right away.
Reply
#4
You're welcomeWink
Done is better than perfect
Reply


Forum Jump: