This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

Problem with LM3 V2
#4
(30.10.2018, 13:32)Daniel. Wrote: Hi
80% for KNX trafic is very high and id doesn't matter if you are connected or not.  It sound to me like some KNX loop. I just looked on manuals of this Comfort Touch and it does support routing so you have to ether switch it off on the touch or on LM otherwise you will have loop.
BR

80% of CPU consumption by KNX backend

~15% KNX traffic

(30.10.2018, 13:28)admin Wrote: Have you tried rebooting the device? Since the device is rather old it might have Siemens TP-UART v5.2 chip which can stop working in specific conditions.

Yes, and this solve for now the problem. This LM I bought in june 2016.
Done is better than perfect
Reply


Messages In This Thread
Problem with LM3 V2 - by buuuudzik - 30.10.2018, 13:14
RE: Problem with LM3 V2 - by admin - 30.10.2018, 13:28
RE: Problem with LM3 V2 - by Daniel - 30.10.2018, 13:32
RE: Problem with LM3 V2 - by buuuudzik - 30.10.2018, 13:42
RE: Problem with LM3 V2 - by Daniel - 30.10.2018, 13:53
RE: Problem with LM3 V2 - by admin - 30.10.2018, 13:55
RE: Problem with LM3 V2 - by buuuudzik - 30.10.2018, 14:18
RE: Problem with LM3 V2 - by buuuudzik - 30.10.2018, 16:01
RE: Problem with LM3 V2 - by admin - 31.10.2018, 08:59
RE: Problem with LM3 V2 - by buuuudzik - 31.10.2018, 09:36
RE: Problem with LM3 V2 - by admin - 31.10.2018, 09:42
RE: Problem with LM3 V2 - by buuuudzik - 01.12.2018, 07:51
RE: Problem with LM3 V2 - by Daniel - 03.12.2018, 08:46
RE: Problem with LM3 V2 - by buuuudzik - 03.12.2018, 09:31
RE: Problem with LM3 V2 - by admin - 03.12.2018, 09:37
RE: Problem with LM3 V2 - by Daniel - 03.12.2018, 09:41
RE: Problem with LM3 V2 - by buuuudzik - 03.12.2018, 10:34

Forum Jump: