This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

Problem with LM3 V2
#10
So what should be the behavior when timer input is empty? Intuitively it shouldn't send new value cyclically.
And what is the difference to send when Multiplier = 10 and value written to the bus is ~30?

On above settings every 10s the value was sended (I've checked this in logs).
Done is better than perfect
Reply


Messages In This Thread
Problem with LM3 V2 - by buuuudzik - 30.10.2018, 13:14
RE: Problem with LM3 V2 - by admin - 30.10.2018, 13:28
RE: Problem with LM3 V2 - by Daniel - 30.10.2018, 13:32
RE: Problem with LM3 V2 - by buuuudzik - 30.10.2018, 13:42
RE: Problem with LM3 V2 - by Daniel - 30.10.2018, 13:53
RE: Problem with LM3 V2 - by admin - 30.10.2018, 13:55
RE: Problem with LM3 V2 - by buuuudzik - 30.10.2018, 14:18
RE: Problem with LM3 V2 - by buuuudzik - 30.10.2018, 16:01
RE: Problem with LM3 V2 - by admin - 31.10.2018, 08:59
RE: Problem with LM3 V2 - by buuuudzik - 31.10.2018, 09:36
RE: Problem with LM3 V2 - by admin - 31.10.2018, 09:42
RE: Problem with LM3 V2 - by buuuudzik - 01.12.2018, 07:51
RE: Problem with LM3 V2 - by Daniel - 03.12.2018, 08:46
RE: Problem with LM3 V2 - by buuuudzik - 03.12.2018, 09:31
RE: Problem with LM3 V2 - by admin - 03.12.2018, 09:37
RE: Problem with LM3 V2 - by Daniel - 03.12.2018, 09:41
RE: Problem with LM3 V2 - by buuuudzik - 03.12.2018, 10:34

Forum Jump: