09.11.2018, 08:48
Hi,
Yes it is as simple as that (: When you want to use a setpoint from KNX in the BMS you just bind it in the BMS to your process and set value transfer direction to -> BMS. Then you could decide to use COV or poll the change every x period depending on how fast you want to react on a changed setpoint. For HVAC it is not realy important to handle it within a second so a small delay in polling would never be noticed by the end user.
BR,
Erwin
Yes it is as simple as that (: When you want to use a setpoint from KNX in the BMS you just bind it in the BMS to your process and set value transfer direction to -> BMS. Then you could decide to use COV or poll the change every x period depending on how fast you want to react on a changed setpoint. For HVAC it is not realy important to handle it within a second so a small delay in polling would never be noticed by the end user.
BR,
Erwin