This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

Problem with LM3 V2
#12
After optimization LM had for a few days CPU usage 0-100% and all was ok but yesterday again I've found that it freezed its KNX IP without any error.

Now it has only one very simple script which do very simple calculation every minute. 3 temperature sensors which sends its value every minute. 3inputs and 3 outputs which are used very rarely. 2 modbus devices(50 objects). No visualisation.

I've did yesterday screenshots:

Attached Files Thumbnail(s)
       
Done is better than perfect
Reply


Messages In This Thread
Problem with LM3 V2 - by buuuudzik - 30.10.2018, 13:14
RE: Problem with LM3 V2 - by admin - 30.10.2018, 13:28
RE: Problem with LM3 V2 - by Daniel - 30.10.2018, 13:32
RE: Problem with LM3 V2 - by buuuudzik - 30.10.2018, 13:42
RE: Problem with LM3 V2 - by Daniel - 30.10.2018, 13:53
RE: Problem with LM3 V2 - by admin - 30.10.2018, 13:55
RE: Problem with LM3 V2 - by buuuudzik - 30.10.2018, 14:18
RE: Problem with LM3 V2 - by buuuudzik - 30.10.2018, 16:01
RE: Problem with LM3 V2 - by admin - 31.10.2018, 08:59
RE: Problem with LM3 V2 - by buuuudzik - 31.10.2018, 09:36
RE: Problem with LM3 V2 - by admin - 31.10.2018, 09:42
RE: Problem with LM3 V2 - by buuuudzik - 01.12.2018, 07:51
RE: Problem with LM3 V2 - by Daniel - 03.12.2018, 08:46
RE: Problem with LM3 V2 - by buuuudzik - 03.12.2018, 09:31
RE: Problem with LM3 V2 - by admin - 03.12.2018, 09:37
RE: Problem with LM3 V2 - by Daniel - 03.12.2018, 09:41
RE: Problem with LM3 V2 - by buuuudzik - 03.12.2018, 10:34

Forum Jump: