10.01.2019, 08:21
Hi
This is how the heating modes works in KNX. Setpoint is shifted +/- X value depend of the mode. If you don't use modes you could adjust the shift to 0 and then all will be OK. Otherwise you can make some sctipt which will add/subtract X for the setpoint status.
BR
This is how the heating modes works in KNX. Setpoint is shifted +/- X value depend of the mode. If you don't use modes you could adjust the shift to 0 and then all will be OK. Otherwise you can make some sctipt which will add/subtract X for the setpoint status.
BR
------------------------------
Ctrl+F5
Ctrl+F5