07.04.2016, 11:41
(This post was last modified: 08.04.2016, 06:05 by gjniewenhuijse.)
1. I think there is something wrong with the paramters. I changed a lot of parameters to non default value in the fibaro FGMS001 motionsensor. This is working now for a day. But when i look at the parameters now i see all the default values and i didn't change anything at the parameters. Also the devices has other parameters then the default.
For example:
- i changed parameter 80 to: Long blink blue
- but when i look now to the parameters i see: long blink, then short blink, color depens.... etc (default value)
But physic i see my device Blinking blue when there's motion detection (the right parameter setting).
After some time: my device parameters physic are also updated to default.
For example:
- i changed parameter 80 to: Long blink blue
- but when i look now to the parameters i see: long blink, then short blink, color depens.... etc (default value)
But physic i see my device Blinking blue when there's motion detection (the right parameter setting).
After some time: my device parameters physic are also updated to default.