15.04.2016, 07:25
Hello,
we are already working on finding the issue/solution with integration of latest Ekey scanners when they are detected but not working properly.
In this case it is strange they are not detected at all. Please try the following:
- if its LM4, please make sure that you use 2nd RS-485.
- scanners normally appear after LM is rebooted.
- make sure that second RS-485 is not taken by any other peripheral like Modbus or DALI.
we are already working on finding the issue/solution with integration of latest Ekey scanners when they are detected but not working properly.
In this case it is strange they are not detected at all. Please try the following:
- if its LM4, please make sure that you use 2nd RS-485.
- scanners normally appear after LM is rebooted.
- make sure that second RS-485 is not taken by any other peripheral like Modbus or DALI.