18.04.2016, 06:00
It is a LM4 and I did start by the second RS485, I switched A and B lines, with a reboot between each try. It is only after that I tried the other ports with no more success.
Of course, I did check the wiring several times.
Concerning DALI, I am with the default LM configuration (from blank) so I assume nothing is active (I could not see anything in the tab), and some Modbus devices are configured but on port 3.
Of course, I did check the wiring several times.
Concerning DALI, I am with the default LM configuration (from blank) so I assume nothing is active (I could not see anything in the tab), and some Modbus devices are configured but on port 3.