(26.04.2019, 11:01)edgars Wrote: Hi Kai,
we have made another device for resistive sensor inputs. For current UIO8 this isn't possible because our inputs are non-potential. In case of PT1000 we need to have internal pull-up resistor (with very good precision, no more than 0.1%) and voltage source for pull-up. That's why we made separate device for this functionality.
By the way, why NTC is preferable and not PT1000?
Hi.
I understand. I'm just a little pampered with some of the products i normally use :)
NTC is just becouse we use have a lot of these since we use them on different KNX products.
Here is an example of a product i see as compact and extremely versatile (excuse my Paint layout). It fits in resident installations like a glove.
If it was possible to make somthing like this with CanX and LoRa antenna, then the word would not need any other products! With a Clip for mounting on DIN rail, one product would be enough in all cases. Almost ;)