15.07.2019, 11:10
Good afternoon
I run a project on a spaceLYnk logic controller and for some reason all objects are gone. I have set no filters.
I use the following hard and software:
HW: spaceLYnk (i.MX6)
SW: 2.3.0
I have rebooted the software but that has not brought about any changes.
If you have any ideas what could've caused this, I'd be glat to hear from you.
Cheers!
Martin
I run a project on a spaceLYnk logic controller and for some reason all objects are gone. I have set no filters.
I use the following hard and software:
HW: spaceLYnk (i.MX6)
SW: 2.3.0
I have rebooted the software but that has not brought about any changes.
If you have any ideas what could've caused this, I'd be glat to hear from you.
Cheers!
Martin