This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › Hardware v
1-wire pullup resistor

Linear Mode
1-wire pullup resistor
Bitver Offline
Member
Posts: 113
Threads: 36
Joined: Oct 2016
Reputation: 1
#5
10.10.2019, 12:02
(08.10.2019, 12:05)admin Wrote: Pull-up is not needed but you can get more reliable readings by adding a capacitor (at least 0.1uF) between +5V and GND as close as possible to the sensor.

Thank you.
Find
Reply


Messages In This Thread
1-wire pullup resistor - by Bitver - 08.10.2019, 10:56
RE: 1-wire pullup resistor - by admin - 08.10.2019, 11:07
RE: 1-wire pullup resistor - by Bitver - 08.10.2019, 11:49
RE: 1-wire pullup resistor - by admin - 08.10.2019, 12:05
RE: 1-wire pullup resistor - by Bitver - 10.10.2019, 12:02

Forum Jump: