06.11.2019, 18:32
Hi,
You need to set the physical address to x.x.0, set the mode to TPUART and make sure that the checkbox IP features is enabled. Optionally you can set the filters to manage the traffic. I would also advise to enable “acknowledge all group telegrams” to avoid possible repeats. Do not change the KNX multicast setting.
With settings above it should work fine.
BR,
Erwin
You need to set the physical address to x.x.0, set the mode to TPUART and make sure that the checkbox IP features is enabled. Optionally you can set the filters to manage the traffic. I would also advise to enable “acknowledge all group telegrams” to avoid possible repeats. Do not change the KNX multicast setting.
With settings above it should work fine.
BR,
Erwin