11.03.2020, 14:45
(This post was last modified: 11.03.2020, 14:59 by Todayslife.
Edit Reason: Graphic
)
(04.03.2020, 16:37)admin Wrote: Yes, it will work
Thank you
After attaching an EnOcean USB equipped with the TCM 310 transceiver gateway module to the LM5
the EnOcean USB controller seems to appear under the EnOcean tab as follows:
Now I am struggling to add an EnOcean device to the configuration.
Being used to KNX-EnOcean Gateways like "KNX ENO 634" from Weinzierl Engineering GmbH, adding a device is as simple as pressing the learning button on the new EnOcean-device:
Unfortunately doing so in the given configuration on the LM5, did not bring anything to appear under the tab of "EnOcean >> KNX":
What else needs to be done/preconfigured?
KR
FYI - Configuration:
HW: LM5 Lite + Ext (i.MX6)
SW: 20190904
EnOcean USB controller with SMA connector:
https://shop.swiss-domotique.ch/en/enoce...ocean.html
EnOcean-Device:
https://nodon.fr/en/nodon/enocean-temper...ty-sensor/