22.04.2020, 14:04
(This post was last modified: 22.04.2020, 14:08 by manos@dynamitec.)
Hello All,
I need to control a Panasonic Projector which is compatible with the PJLINK (TCP/IP) protocol on port 4352.
I will need to send some hex or character commands to the IP 192.168.1.98 port 4352. Please see below example:
Power ON :
CHARACHTER => %1POWR(SP)0(CR)
HEX => 25 31 50 4f 57 52 20 30 0d
Can this be done via an event script triggered by a virtual object?
HomeLynk V3.0 FW:2.4.0
Thank you in advance
I need to control a Panasonic Projector which is compatible with the PJLINK (TCP/IP) protocol on port 4352.
I will need to send some hex or character commands to the IP 192.168.1.98 port 4352. Please see below example:
Power ON :
CHARACHTER => %1POWR(SP)0(CR)
HEX => 25 31 50 4f 57 52 20 30 0d
Can this be done via an event script triggered by a virtual object?
HomeLynk V3.0 FW:2.4.0
Thank you in advance