14.08.2020, 12:36
Hello,
I am using LM5 Lite with KNX system and there are Hager TYA670D DALI gateways to control DALI luminaires. The gateway can give 1byte and 2byte error status. I want to show individual failure message for per DALI load on the visualization page.
- How can I use these error status messages?
- Is there any visualization template about this?
Thanks and regards,
İbrahim.
I am using LM5 Lite with KNX system and there are Hager TYA670D DALI gateways to control DALI luminaires. The gateway can give 1byte and 2byte error status. I want to show individual failure message for per DALI load on the visualization page.
- How can I use these error status messages?
- Is there any visualization template about this?
Thanks and regards,
İbrahim.