This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

ModBus TCP slave problem
#1
Hi,

need a little explanation from more experienced persons.

I use LM like Modbus TCP slave device. I need read/write over it to KNX devices. All was done fine and works, till I need to add one more, 12th knx thermostat.

I used 124 registers. When I added new device and add registers, I found out I cannot read over 125 register or write over 123.. Is possible to solve somehow this problem? At scanner max 125 registers (picture below), and I cannot read as example register 126..

BR,

Alex

   
Reply


Messages In This Thread
ModBus TCP slave problem - by AlexLV - 29.09.2020, 20:49
RE: ModBus TCP slave problem - by admin - 30.09.2020, 05:05
RE: ModBus TCP slave problem - by AlexLV - 30.09.2020, 12:52
RE: ModBus TCP slave problem - by admin - 30.09.2020, 13:02
RE: ModBus TCP slave problem - by AlexLV - 30.09.2020, 13:27

Forum Jump: