This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › General v
KNX Router and LM

Linear Mode
KNX Router and LM
Ibrahim Offline
Junior Member
Posts: 43
Threads: 8
Joined: Mar 2020
Reputation: 0
#5
03.11.2020, 13:02
Yes, TP of 1.1 line is connected to LM. Ok, I will change it to TP-Uart. I meant group addresses but when I selected the TP-Uart then the LM can get data from 1.1 but not 1.2 Also there is no filter. What else to check?
Thanks.
Find
Reply


Messages In This Thread
KNX Router and LM - by Ibrahim - 03.11.2020, 10:28
RE: KNX Router and LM - by Daniel - 03.11.2020, 10:35
RE: KNX Router and LM - by Ibrahim - 03.11.2020, 12:49
RE: KNX Router and LM - by Daniel - 03.11.2020, 12:54
RE: KNX Router and LM - by Ibrahim - 03.11.2020, 13:02
RE: KNX Router and LM - by Daniel - 03.11.2020, 13:07
RE: KNX Router and LM - by Tokatubs - 03.11.2020, 18:10
RE: KNX Router and LM - by Ibrahim - 03.11.2020, 23:20
RE: KNX Router and LM - by Ibrahim - 04.11.2020, 09:51
RE: KNX Router and LM - by admin - 04.11.2020, 09:56
RE: KNX Router and LM - by Ibrahim - 04.11.2020, 11:27
RE: KNX Router and LM - by Daniel - 04.11.2020, 12:21
RE: KNX Router and LM - by Ibrahim - 04.11.2020, 14:34
RE: KNX Router and LM - by Ibrahim - 14.11.2020, 09:47
RE: KNX Router and LM - by admin - 15.11.2020, 09:03

Forum Jump: