09.11.2020, 12:44
Hmm. It appears that I might have mistaken the basic concepts although I still don't have it confirmed.
I thought I could use the LM5 as a modbus gateway for KNX such that I could access the group addresses set up for modbus on LM5 inside ETS5. Is this not possible?
Furthermore, in ETS5 the electrician has programmed e.g. this Hvac max air setting with one group address connected to the various triggers (KNX buttons and sensors). In LM5 I can see this group address ofcourse, but not the specific buttons etc. related to the KNX hardware. My idea was that I should be able to just use the LM5 modbus created group address in ETS5 instead of the current group address...
If this is not possible I will have to control the modbus group address inside LM5 which is not exactly what I wanted to do...
I thought I could use the LM5 as a modbus gateway for KNX such that I could access the group addresses set up for modbus on LM5 inside ETS5. Is this not possible?
Furthermore, in ETS5 the electrician has programmed e.g. this Hvac max air setting with one group address connected to the various triggers (KNX buttons and sensors). In LM5 I can see this group address ofcourse, but not the specific buttons etc. related to the KNX hardware. My idea was that I should be able to just use the LM5 modbus created group address in ETS5 instead of the current group address...
If this is not possible I will have to control the modbus group address inside LM5 which is not exactly what I wanted to do...