This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › Gateway v
LM5 and KNX integration - how should you work with programming

Linear Mode
LM5 and KNX integration - how should you work with programming
admin Offline
Administrator
Posts: 7758
Threads: 42
Joined: Jun 2015
Reputation: 447
#7
09.11.2020, 13:02
By default LM is a transparent bridge between KNX/TP and any other protocols. Any group message from KNX/TP will appear in LM and vice versa. For modbus control just make sure that your KNX button and LM Modbus mapping have the same group address. It will work automatically.
Find
Reply


Messages In This Thread
RE: LM5 and KNX integration - how should you work with programming - by admin - 09.11.2020, 13:02

Forum Jump: