18.12.2020, 12:51
Hi,
I need some help regarding a DSE7320 power generator controller.
I am having trouble to understand what should i send on modbus in order to select a workig mode (for example "Select Stop mode")
The manual states:
"The register array is divided into 256 pages each containing up to 256 registers, the actual register address is obtained from the formula:
register_address=page_number*256+register_offset."
"One of the system control keys from the table below must be written into register 8 and its ones-compliment written into register 9 with a single function 16 (write multiple registers) to perform the specified system control function."
Below are the two pages with the control functions and it's address
Any help would be much appreciated.
Thank you in advance
George
I need some help regarding a DSE7320 power generator controller.
I am having trouble to understand what should i send on modbus in order to select a workig mode (for example "Select Stop mode")
The manual states:
"The register array is divided into 256 pages each containing up to 256 registers, the actual register address is obtained from the formula:
register_address=page_number*256+register_offset."
"One of the system control keys from the table below must be written into register 8 and its ones-compliment written into register 9 with a single function 16 (write multiple registers) to perform the specified system control function."
Below are the two pages with the control functions and it's address
Any help would be much appreciated.
Thank you in advance
George