This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › General v
Wiser for KNX and modbus problem

Linear Mode
Wiser for KNX and modbus problem
Daniel Offline
Administrator
Posts: 4646
Threads: 24
Joined: Aug 2017
Reputation: 207
#24
24.02.2021, 09:38
Two weeks ago I was helping in one installation. 16 slaves where two were the PM3255 you have. Everything just worked but the cabling was spot on. If you are confident about cables I would disconnect all slaves and try them one by one.
------------------------------
Ctrl+F5
Find
Reply


Messages In This Thread
RE: Wiser for KNX and modbus problem - by Daniel - 24.02.2021, 09:38

Forum Jump: