03.03.2021, 16:51
Thanks Daniel for your support,
After two days walking around and disassembling half of the electrical panel, I confirm that in my installation the spacelynk firmware 2.6.0 does not seem to work properly as a knxIpTunneling to program knx devices with ets 5.7. With fw 2.5.1 there is not this issue.
Now most of the menus on the "system" page do not work, like "upgrade", "shutdown", "knx connection" .... I forced a reboot to see if it would work but it did not.
And CPU looks overload, over 88%, before the normas is between 5 and 15%
Could you help me? thanks a lot,
After two days walking around and disassembling half of the electrical panel, I confirm that in my installation the spacelynk firmware 2.6.0 does not seem to work properly as a knxIpTunneling to program knx devices with ets 5.7. With fw 2.5.1 there is not this issue.
Now most of the menus on the "system" page do not work, like "upgrade", "shutdown", "knx connection" .... I forced a reboot to see if it would work but it did not.
And CPU looks overload, over 88%, before the normas is between 5 and 15%
Could you help me? thanks a lot,