27.03.2021, 15:38
This have also happened to me. I have seen from time to time, not often, more like once a year that it hangs and does not respond to anything. A power cycle usually takes care fo the problem.
However this time it is probably more severe. I have a reactor v3 and I tried to use it as a gateway for ets5 to try to program my knx switches. There was no response in ETS so I tried to change the config in IP routing or IP tunnelling, dont remember now which one it was.
when I rebooted I can ping it and the automation works like before. My lights turns on and off at the correct times during the day.
I tried to reset networking and managed to do that but HTTP didnt respond anyway. I am reluctant to do a full hardware reset because I cannot find my backup.
Any other way to access it? Have tried SSH but that didnt work either.
Do I need to flash the SD card if it exist in my unit?
However this time it is probably more severe. I have a reactor v3 and I tried to use it as a gateway for ets5 to try to program my knx switches. There was no response in ETS so I tried to change the config in IP routing or IP tunnelling, dont remember now which one it was.
when I rebooted I can ping it and the automation works like before. My lights turns on and off at the correct times during the day.
I tried to reset networking and managed to do that but HTTP didnt respond anyway. I am reluctant to do a full hardware reset because I cannot find my backup.
Any other way to access it? Have tried SSH but that didnt work either.
Do I need to flash the SD card if it exist in my unit?