29.03.2021, 10:48
You are probably using virtual addresses, those are not exposed on KNX IP so the other controller is not getting the values.
Use adresses 0/x/x to 31/x/x
Use adresses 0/x/x to 31/x/x
|
SpaceLynk "import neighbours" issue
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
SpaceLynk "import neighbours" issue - by Kilogica - 29.03.2021, 10:02
RE: SpaceLynk "import neighbours" issue - by Erwin van der Zwart - 29.03.2021, 10:48
RE: SpaceLynk "import neighbours" issue - by Kilogica - 29.03.2021, 11:12
RE: SpaceLynk "import neighbours" issue - by Erwin van der Zwart - 30.03.2021, 08:19
RE: SpaceLynk "import neighbours" issue - by Kilogica - 30.03.2021, 08:28
RE: SpaceLynk "import neighbours" issue - by Krists - 27.12.2022, 13:31
RE: SpaceLynk "import neighbours" issue - by Daniel - 28.12.2022, 09:54
RE: SpaceLynk "import neighbours" issue - by Krists - 29.12.2022, 06:52
RE: SpaceLynk "import neighbours" issue - by Daniel - 29.12.2022, 10:48
RE: SpaceLynk "import neighbours" issue - by Krists - 09.01.2023, 13:34
RE: SpaceLynk "import neighbours" issue - by Daniel - 09.01.2023, 14:28
RE: SpaceLynk "import neighbours" issue - by Krists - 09.01.2023, 15:03
|