ETS5 -> Reactor3 -> KNX Devices

[Bobby]

Hi!
I am new to this.
I have ETS5, and i have successfully connected this to LM.
However, i am not able to find any devices in programming mode. i have tried 2 knx devices, both in programming mode.

My setup is:

Reactor 3 - Mean Well  KNX-20E-640 ( http://www.sunpower-uk.com/product/19-2W...efault.htm )
- Jung DS4092TS and Gira Mini Komfort sensor.


in lm, i have standard settings:

General tab
 Mode [ TP-UART / EIBnet IP Tunneling / EIBnet IP Tunneling(NAT mode) / EIBnet IP Routing] – KNX connection mode. LogicMachine Reactor has TPUART interface by default built-in. Note! If there is no KNX TP connected to the device, it will automatically offer to switch to KNXnet/IP mode.
 ACK all group telegrams – acknowledge receipt of telegram to all group communication
 Parameter–KNX corresponding interface in OS of the system
 KNX address – KNX physical address of the device
 KNX IP features – Use this device with KNX IP features e.g. for KNXnet/IP network configuration
 Multicast IP – multicast IP address
 Multicast TTL – Time to live for multicast telegram in seconds
 Maximum telegrams in queue – count of maximum telegrams in the queue


any suggestions?

Bobby