This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › General v
KNX RX TX not working

Linear Mode
KNX RX TX not working
admin Offline
Administrator
Posts: 7758
Threads: 42
Joined: Jun 2015
Reputation: 447
#8
08.07.2021, 09:16
When TP is not connected there's a warning message. If you have clicked "yes" then it would have switched the KNX connection mode to IP instead of TP .
Find
Reply


Messages In This Thread
RE: KNX RX TX not working - by Daniel - 07.07.2021, 07:22
RE: KNX RX TX not working - by Daniel - 08.07.2021, 08:29
RE: KNX RX TX not working - by Daniel - 08.07.2021, 08:54
RE: KNX RX TX not working - by admin - 08.07.2021, 09:16

Forum Jump: