LM as KNX / IP Interface

Linear Mode

LM as KNX / IP Interface

vmic

Offline

Member

Posts: 93
Threads: 23
Joined: Oct 2020
Reputation: 0

#1

26.10.2021, 11:36 (This post was last modified: 26.10.2021, 11:38 by vmic.)

Hi!
I would like to use the LM Lite 5 Power DR as a KNX gateway but unfortunetally I cna; program KNX devices using ETS5 cuase I am receiving some error messages.
I am sending you the images to see . I changed the KNX address of the LM device but still the problem exists.
Any ideas on how to resolve this issue please?

Attached Files Thumbnail(s)

Find

Reply

« Next Oldest | Next Newest »

Messages In This Thread

LM as KNX / IP Interface - by vmic - 26.10.2021, 11:36

RE: LM as KNX / IP Interface - by Daniel - 26.10.2021, 13:29

RE: LM as KNX / IP Interface - by vmic - 26.10.2021, 14:29

RE: LM as KNX / IP Interface - by Daniel - 26.10.2021, 15:07

RE: LM as KNX / IP Interface - by vmic - 26.10.2021, 15:30

RE: LM as KNX / IP Interface - by Daniel - 26.10.2021, 15:33

RE: LM as KNX / IP Interface - by vmic - 26.10.2021, 16:12

RE: LM as KNX / IP Interface - by Daniel - 26.10.2021, 16:20

RE: LM as KNX / IP Interface - by vmic - 26.10.2021, 18:45

RE: LM as KNX / IP Interface - by Daniel - 27.10.2021, 07:36

RE: LM as KNX / IP Interface - by Daniel - 27.10.2021, 07:40

RE: LM as KNX / IP Interface - by Daniel - 27.10.2021, 07:44

RE: LM as KNX / IP Interface - by vmic - 27.10.2021, 07:47

RE: LM as KNX / IP Interface - by Daniel - 27.10.2021, 08:56

RE: LM as KNX / IP Interface - by vmic - 27.10.2021, 09:00

View a Printable Version