DALI: No feedback from the ballast comes in
|
DALI: No feedback from the ballast comes in
|
28.10.2021, 13:02
There are some ballasts that do not adhere to the DALI standard voltage levels when transmitting. This can explain why LM can control them but cannot read the status info. If you say that it worked before then check the wiring. Maybe some contact points became worse over time increasing the total line resistance.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
DALI: No feedback from the ballast comes in - by Andrey Esaulov - 28.10.2021, 09:06
RE: DALI: No feedback from the ballast comes in - by Daniel - 28.10.2021, 09:49
RE: DALI: No feedback from the ballast comes in - by Andrey Esaulov - 28.10.2021, 10:08
RE: DALI: No feedback from the ballast comes in - by Daniel - 28.10.2021, 13:01
RE: DALI: No feedback from the ballast comes in - by admin - 28.10.2021, 13:02
|
