I have a HomeLynk, early version before the "wiser" range.
On the side of the unit, it says "version 1.2", doesn't state anything about HW/SW version as pictures in the SE firmware manual.
I noticed the HL dissapered from the network a couple of weeks ago and the KNX communication wnt down aswell, I tried to reeboot it a couple of time but still no sucess.
So I followed this manual;
Reflash LogicMachine and Streaming Player software | Logic Machine platform for KNX/EIB, EnOcean, Modbus, DALI, BacNet (openrb.com)
And reflashed the old SD-card with HL HW1 restore IMG. Still no sucess.
I tested another SD card, formatted it as in the manual and reflashed it. Still no connection
Only difference I can notice, is that with the old SD-card, I can perform HW-reset via the button, but with the new SD-card, nothing happens when pushing down the button 10 seconds, it's stuck in the blink loop not responding the button press-down.
The new card is a Samsung 32Gb
With old SD card, LED 2 is on, with new SD, only LED 1 blinks, LED 2 is off.
See theese short vid on youtube;
Old SD-card new flashed IMG; 1 december 2021 - YouTube
New SD-card new flashed IMG; 1 december 2021 - YouTube
Find it funny that they behave different, even though both are flashed with same IMG.
I have tried connect the HL to network switch, but also directly to the laptop.
I've tried browsing to 192.168.0.10 but also ping the IP. No response at all, all packets lost.
As the attached picture, I assume this is HW 1? So the correct IMG have been loaded?
Edit; Does HL V3.1 have SPI or SD-card for SW storage?
On the side of the unit, it says "version 1.2", doesn't state anything about HW/SW version as pictures in the SE firmware manual.
I noticed the HL dissapered from the network a couple of weeks ago and the KNX communication wnt down aswell, I tried to reeboot it a couple of time but still no sucess.
So I followed this manual;
Reflash LogicMachine and Streaming Player software | Logic Machine platform for KNX/EIB, EnOcean, Modbus, DALI, BacNet (openrb.com)
And reflashed the old SD-card with HL HW1 restore IMG. Still no sucess.
I tested another SD card, formatted it as in the manual and reflashed it. Still no connection
Only difference I can notice, is that with the old SD-card, I can perform HW-reset via the button, but with the new SD-card, nothing happens when pushing down the button 10 seconds, it's stuck in the blink loop not responding the button press-down.
The new card is a Samsung 32Gb
With old SD card, LED 2 is on, with new SD, only LED 1 blinks, LED 2 is off.
See theese short vid on youtube;
Old SD-card new flashed IMG; 1 december 2021 - YouTube
New SD-card new flashed IMG; 1 december 2021 - YouTube
Find it funny that they behave different, even though both are flashed with same IMG.
I have tried connect the HL to network switch, but also directly to the laptop.
I've tried browsing to 192.168.0.10 but also ping the IP. No response at all, all packets lost.
As the attached picture, I assume this is HW 1? So the correct IMG have been loaded?
Edit; Does HL V3.1 have SPI or SD-card for SW storage?