02.01.2022, 11:52
Good morning everyone;
i'm a newbie on programming and home automation and i'm facing some issues with my homelynk.
In my system i have a Nibe heat pump, already connected and working with modbus (partially with the help of some topics here)
and a ventilation unit made by an Italian builder, and with this one I can't get anything working from modbus.
Homelynk is the master of my modbus network and is properly wired to the modbus Nibe module, then from this the Ventilation unit is wired with 3 m of cable. Total length of the wiring is around 20m, no terminations resistor in place.
I have attached here the modbus manual of this unit (unfortunately only in italian).
Any suggestion on how to get this working?
I'd really appreciate some help! thank you all in advance for any reply!
BR
Luca
i'm a newbie on programming and home automation and i'm facing some issues with my homelynk.
In my system i have a Nibe heat pump, already connected and working with modbus (partially with the help of some topics here)
and a ventilation unit made by an Italian builder, and with this one I can't get anything working from modbus.
Homelynk is the master of my modbus network and is properly wired to the modbus Nibe module, then from this the Ventilation unit is wired with 3 m of cable. Total length of the wiring is around 20m, no terminations resistor in place.
I have attached here the modbus manual of this unit (unfortunately only in italian).
Any suggestion on how to get this working?
I'd really appreciate some help! thank you all in advance for any reply!
BR
Luca